ONKYO CD-S501S Manuel d'instructions télécharger pdf (Page 18)

Connecting the DVD receiver—Continued

Connecting the Speaker Cables

The following illustration shows which speaker should

be connected to each pair of terminals.

Connecting a Powered Subwoofer

Using a suitable cable, connect the DVD receiver’s SUB-

WOOFER PRE OUT to an input on your powered sub-

woofer, as shown.

Speaker Impedance

If the impedance of any of front speakers is 4 ohms or

more but less than 6, set the speaker impedance to

“4:~16:”.

Note:

Change of the settings may be required for some speak-

ers (see page 55).

Strip about 15 mm of insu-

lation from the ends of the

speaker cables, and twist

the bare wires tightly, as

shown.

Unscrew the terminal.

Fully insert the bare

wires.

Screw the terminal tight.

15 mm

Front right

speaker

Front left

speaker

LINE INPUT

Powered

subwoofer

Use the SPEAKER IMPEDANCE SELEC-

TOR to select speaker impedance.

:~16::

Select if the impedance of any of speakers is 4

ohms or more but less than 6.

:~16::

Select if the impedances of all speakers are

between 6 and 16 ohms.

SPEAKER IMPEDANCE

SELECTOR

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 83 84

Pas de commentaire

ONKYO CD-S501S Manuel d'instructions Page 18