ONKYO DV-SP402E Manuel d'utilisateur télécharger pdf (Page 17)

Connecting the DV-SP402E—Continued

The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In

this setup, stereo audio is played through the speakers in your TV.

• This player is equipped with copy protection technol-

ogy. Do not connect this player to your TV via a VCR

using AV cables, as the picture from this player will

not appear properly on your TV. (This player may also

not be compatible with some combination TV/VCRs

for the same reason; refer to the manufacturer for more

information.)

• When connecting to your TV as shown above, do not

set the “Component Out” setting (page 41) to “Pro-

gressive.”

1. Connect the VIDEO OUTPUT and AUDIO OUT-

PUT ANALOG L/R jacks to a set of A/V inputs

on your TV.

Use the supplied AV cable (RCA/phono), connecting

the red and white plugs to the audio outputs and the

yellow plug to the video output. Make sure you

match up the left and right audio outputs with their

corresponding inputs for correct stereo sound.

See the following page if you want to use a compo-

nent or S-Video cable for the video connection.

2. Connect the supplied AC power cord to the AC

INLET, then plug into a power outlet.

Notes:

• Before unplugging the player from the power outlet,

make sure you ﬁrst switch it into standby using either

the front panel STANDBY/ON button, or the remote

controller, and wait of the “GOOD BYE” message to

disappear from the player’s display.

•For the above reasons, do not plug this player into a

switched power supply found on some ampliﬁers and

AV receivers.

Important:

• When Component Out (page 41) is set to Progressive,

there is no video output from the VIDEO OUTPUT

(composite) and S VIDEO OUTPUT jacks.

• If you want to display video on more than one monitor

simultaneously, make sure the player is set to Inter-

lace.

• If you connect a TV that is not compatible with a pro-

gressive scan signal and switch the player to progres-

sive, you will not be able to see any picture at all. In

this case, switch everything off and reconnect using

the supplied video cable, then switch back to Interlace

(see page 18).

Basic Setup

AV CONNECTOR

MODEL NO. DV

402E

OPTICAL COAXIAL

DIGITAL

AUDIO OUTPUT

VIDEO

OUTPUT

VIDEO

ANALOG

AUDIO

OUTPUT

COMPONENT

YPB

REMOTE

CONTROL

INLET

ANALOG

INPUT

VIDEO IN

To power outlet

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

ONKYO DV-SP402E Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD ONKYO DV-SP402E